| |
 |
  
The Elevator Controller is a stand-alone unit similar to our door controllers. Each panel has a unique address indicated on the PLCC chip in the center of the board. If button sensing is disabled when a valid card is presented, all relays that card is good for will be thrown for the programmed time. If the button sensing is enabled when a valid card is presented the system will wait for a button to be pressed (for programmed time) then if the cardholder is valid for that floor, the respective relay will be thrown for the programmed time. Connects easily to the Hartmann Access system using 4 wires.
Includes one proximity reader to install in Elevator
Floor control
With Or without button sensing
Battery back up Circuitry
On board firmware clock
Supports Weigand 26 bit format (others on special request)
60,000 user on board storage
2000 event on board storage
Power Requirements: 16.5VAC @ 40VA transformer
Option Stand By battery 12VDC 7.0Ah
Relays are Form C contact rated at 10A 125VAC
On board LED to indicate communications, Active Relays, AC source, as well as the state of the inputs.
|
We do not now and never will give or sell
any information you have given to us. Period!
![](http://us.st11.yimg.com/us.st.yimg.com/I/853111_1584_152383.jpg"<br)
![We take these credit cards](http://us.st11.yimg.com/us.st.yimg.com/I/853111_1783_1593278.jpg")
We also accept Paypal for US orders to confirmed addesses only.
![](http://us.st11.yimg.com/us.st.yimg.com/I/853111_1606_231244.jpg") We are proud to be
A top rated store!
Phone: 561 479-0498
Fax: 781 459-0498
Skype: nokeycom
Have a question or comment? e-mail us!
We look forward to hearing from you!
In This Business Since 1978
|
|
| | |
