The new Victor keyless electronic lock is unique for several reasons. Since it can be set as either storeroom or passage function it can be viewed as two diiferent locks.

Set as a passage function will work this way: The bottom lever latch will only latch the door closed and not lock it, once it is open. The top dead bolt and bottom spring latch will be locked from either side by pulling up on the lever handle all the way up.
Or set as a storeroom funtion will work like this: Door closes and automatically locks from the outside by bottom latch. Free to unlock from the inside by turning lever. Enter code and lock unlocks the latch. In addition, to lock the upper deadbolt from the outside, enter correct code and pull up on lever. Now both bottom latch and upper deadbolt are locked. Enter correct code and push outside lever down and both latch and deadbolt unlock together. Unlocking from the inside is always the same by pushing down on the inside lever. If both latch and bolt are locked then just pressing down on the inside lever will unlock both together. A great feature. Another great feature is how easy it is to lock the deadbolt - Just lift the lever handle from either side.


Features

Simple touch numeric digital keypad

Custom set codes from 4 to 6 digits

Stores up to 8 codes

Easy to program

Incorrect Code Warning Alarm - if incorrect code is entered three times

Alarm is activated and flashing red light indicates entry has been attempted with an incorrected code

Long lasting battery life; 30,000 entries or one to two years of stand-by life

Easy to operate; just lift the lever handle to lock and press down to unlock

Codes can be set/deleted in less than 15 seconds

Easy to rehand - no need to order left or right

Can be either passage function or storeroom function. Easy to change.
















Specifications:
Can be used on exterior doors to 0 degrees Fahrenheit
Door Thickness: 1-3/8" to 2" (35mm and 45mm
Back Set 2-3/8" and 2-3/4" (60mm and 70mm) variable
Distance between latch and deadbolt: 5 1/2"
Lock body: 2-3/4" W x 8-3/8" H - see diagram below for more dimensions
Latch bolt throw: 1/2" (12.7 mm)
Deadbolt throw: 1" (25.4 mm)

Manufactures Warranty:
2 years Exterior finish
5 Years mechanical warranty
5 years on electronic warranty



Please note: This lock comes with latch and bolt that will work with both 2 3/8 and 2 3/4 inch backsets. In addition, either passage or storeroom functiom may be set up - your choice.





There have been a lot of questions about this product so the following FAQ should help:

Questions:
1. Can I reverse hands? Yes. Our locks can be rehanded left or right without disassembling the lock case.



2. Can I change lock function from entry to storeroom funtion? Yes, the unique and simple patented lockset mechanism is flexible to fit to passage or storeroom.



3. Are you planning to get "UL" approval? Yes, We plan to get UL approval in the near future.



4. How hard is it to install the lock? It is very easy to install. We provide free charge door preparation jig and strike position locator to help you to install our locks.



5. If there are 2 cylindrical holes on my door and center distance is not 5 1/2 inches, can I use your locks? No - only 5 1/2 inches on center.



6. Why my burglar alarm sounds? The burglar alarm will sound when emergency key is used, if the batteries or electronics are operating normally. The alarm will sound for 10 seconds and quit for 6 seconds. This cycle will be repeated 8 times.



7. Why does red light will glow? Red light will glow when a wrong code is entered.



8. Why do both Red and Green do flashing and Beeper alarm sounds? Both Red and Green are flashing indicates that the entry has been attempted with an incorrect code 3 times. Beeper alarm activates after three incorrect codes are entered, and blocks further attempts of entry for two minutes.



9. How long do we need replace batteries? We suggest every two years (for the keypad model), and one year (for the remote controller model), even if the yellow light does not glow. To remove the battery housing: insert tool in the pinhole at the center-left of the inner escutcheon, depress to release and remove the housing, replace batteries.



10. Can we use chemicals to clean or polish our lock? Do not use chemicals or abrasive materials to clean the lock.



11. How can we open the code cover? Insert tool into the pinhole at top right side of the excutcheon and depress to release code cover.



12. How can we unlock, If we can not release the lock by digital keypad? You can use Emergency Key in case of battery or electronic failure. The keyholes is located on the outer escutcheon near the doorjamb side. We suggest do not use Emergency key as a mechanic override key, please fix the electronic failure as soon as possible.