This new single door and easy to set up Proximity system is a 2 piece system so the sensitive electronics portion is installed inside the protective area. Only the reader is installed outside by the door.
The system consists of two parts, a vandal and weather resistant mullion mount proximity reader and a small programmer/controller which is installed on the secure side of the facility. This is a more secure type of proximity system then the single all in one systems. The system has a capacity of 999 users. Cards and fobs can be individually or batch enrolled/deleted. All programming is done through the controller and reader -
there is no need for computers or software to enroll or delete cardholders.
See below to order cards or fobs or both.
Up to 999 users
Jamb mount proximity reader
12/24V AC/DC operation
Up to 200 feet (70 metres) between reader and controller
Request to exit input (N/O)
Form C relay - 5 amps
Bi-color LED and sounder
Door open time: 1-180 seconds or latching
Dimensions:
Reader: 1 1/8 inches W X 3 3/4 inches H X 1/2 inches D (23 X 95 X 12 MM)
Controller: 2 3/4 inches W X 3 1/2 inches H X 2 1/4 inches D (70 X 90 X 60 MM)
Related Products
See our electric strike and magnetic lock section
Heater kit for cold weather
See the book: The Guide to Electronic Locksmithing for installation hintsDon't forget the power supply!
Click here for power supply with battery back-up
Important! Please note: always use a separate power supply when using a proximity card reader and an electric strike or magnetic lock.